Search History
Clear
Trending Searches
Refresh

Prefere Resins UK Fined Over £100,000 by Environment Agency

Plastmatch 2026-11-18 09:59:27

According to a statement issued by the Environment Agency on 17 November, Prefere Resins UK Ltd, the UK subsidiary (based in Newton Aycliffe, UK) of Prefere Resins Holding GmbH (Erkner, Germany), was fined following an investigation by the UK Environment Agency for failing to establish appropriate management systems to prevent pollution.

The statement said that Prefere Resins UK was fined £103,850 when it appeared at Newton Aycliffe Magistrates’ Court on 13 November, adding that it was also ordered to pay costs and a victim surcharge totaling £18,784.61.

The statement said that the company admitted to one charge of illegally discharging waste liquid into land and two charges of failing to establish management systems to prevent pollution at the hearing on June 16.

Companies that use hazardous chemicals are responsible for managing them safely. They must establish appropriate systems to protect the community and the environment. Prefere failed to properly manage its site, thereby placing the environment at risk. Gary Wallace, Regional Environment Manager at the Environment Agency, stated, “This court outcome should send a message to others that we will always take action when companies fail to meet the required standards.”

Prefere Resins UK Ltd. manufactures and sells phenol-based products. The company states that phenol is a toxic and corrosive chemical used in the production of plastics and resins. It warns that phenol may harm human health, is harmful to aquatic life, and can contaminate soil and water if released into the environment.

Numerous security vulnerabilities

The statement said that the court heard that officials from the Environmental Protection Agency conducted an unannounced visit to the site in July 2024, when part of the factory was shut down for maintenance. The company’s new Safety, Health and Environment Manager told the officials that he had identified numerous gaps in the on-site procedures.

According to the statement, the company was draining and flushing a phenol recovery column unit in preparation for maintenance. Environment Agency officials stated that they found a flexible hose connected to the equipment, with its open end resting on bare ground. They added that an area of approximately 70 square meters was scorched, brown, and devoid of vegetation, with damp soil and a chemical odor.

Soil samples indicate that phenol levels in the affected areas are extremely high, with one laboratory recording a concentration of up to 3,640 mg/kg and another recording up to 10,000 mg/kg; according to the statement, these levels are harmful to the environment.

The statement said that, meanwhile, historical data and satellite images showed that the land had not been contaminated before. It added that after the incident, the company carried out remediation work on the land to remove the contamination.

Although no impact on groundwater was detected, the site is located within a groundwater protection zone, and there is a risk of contamination from discharging pollutants into the land. According to the statement, Environment Agency officials found that the company lacked written procedures for cleaning pumps at the base of the phenol recovery unit.

The statement further noted that UNEP officials found incompatible chemicals stored together, with containers positioned in such a way that their contents could escape the containment area in the event of a leak. It added that the accidental mixing of chemicals could lead to fires, explosions, or the release of toxic gases.

The statement said that Prefere Resins UK subsequently revised its operating procedures.

The Environment Agency is an executive non-departmental public body sponsored by the UK Government’s Department for Environment, Food and Rural Affairs.

【Copyright and Disclaimer】The above information is collected and organized by PlastMatch. The copyright belongs to the original author. This article is reprinted for the purpose of providing more information, and it does not imply that PlastMatch endorses the views expressed in the article or guarantees its accuracy. If there are any errors in the source attribution or if your legitimate rights have been infringed, please contact us, and we will promptly correct or remove the content. If other media, websites, or individuals use the aforementioned content, they must clearly indicate the original source and origin of the work and assume legal responsibility on their own.

1000+  Daily Updated Global Business Leads,2M+ Global Company Database.Click to download the app.

Purchase request Download app